New Jersey roofing cost guide
Get a preliminary roof replacement range from Done Rite Roof Repair – Exteriors before sharing your contact information. Enter the approximate roof area, choose a roofing system, and select the roof pitch.
Your result is shown immediately and no contact information is required.
Preliminary planning range
$0–$0
This is an informational planning range, not a binding quote. Final pricing depends on the measured roof, access, tear-off layers, decking condition, flashing, ventilation, permits, roof complexity, and material selections. A site inspection is required for an accurate proposal.
These installed ranges are intended for early budgeting for a residential roof replacement. They are broad on purpose because New Jersey projects vary significantly by pitch, access, roof geometry, and existing roof condition.
| Roofing system | Planning range | Typical use |
|---|---|---|
| Architectural asphalt shingles | $6.50–$10.00 / sq. ft. | Most pitched residential roofs |
| Metal roofing | $12.00–$22.00 / sq. ft. | Long-life pitched roof systems |
| Flat roof membrane | $8.00–$16.00 / sq. ft. | Low-slope and flat roof sections |
Rates are a general New Jersey planning baseline researched from current published NJ roofing cost guides. They are not a promise of final pricing.
Steep roofs require additional safety equipment, slower installation, and more labor.
Damaged plywood or roof framing is confirmed after tear-off and priced according to the actual area needing replacement.
Valleys, dormers, hips, chimneys, skylights, and multiple roof transitions add flashing and installation time.
Stories, limited staging space, long carries, permits, and multiple tear-off layers can affect the project total.
No. It is an early planning range. An accurate quote requires a roof measurement and inspection of the existing roofing, decking, flashing, and access conditions.
Floor area is not the same as roof area. Roof pitch, overhangs, dormers, and multiple sections increase the actual roof surface. Use the roof area when possible, or treat the result as a rough starting point.
The baseline assumes ordinary replacement conditions. Localized plywood replacement, structural repairs, or extensive water damage can increase the final cost and should be confirmed during the inspection.